Lenz Digital plus SILVERmini+ Mode D'emploi page 27

•
function output A (white cable) to the bulb which is at the front in relation to the direction of
travel
•
function output B (yellow cable) to the bulb which is at the back in relation to the direction of
travel
If the functions inside the locomotive (e.g. the bulbs of the direction-dependent lights) are not
electrically connected to the chassis (i.e. if they are "potential-free"), connect the other pole of the
function to the blue cable as shown in the illustration. If a connection between functions and chassis
does exist, the blue cable remains unused. When connected to the blue cable, the bulbs shine
somewhat brighter and, in addition, the direction-dependent lighting then also works in normal DC
operation. Which option you choose depends on the design of the locomotive.
For the connection of the LEDs, note that the blue cable is the positive pole (anode side of the LED)
and the function output is the negative pole (cathode side of the LED). The voltage at the function
output is approx. 16 V. Please do not forget the necessary protective resistor.
3 Installing the SILVERmini+ decoder via interface plug NEM651 (Abb. 2, p. 4)
These decoders come with a NEM651 medium plug. This plug makes the installation of these
decoders very simple.
To install the decoder simply remove the dummy plug in your locomotive and install the decoder
plug. To ensure the headlights work correctly you must align the plug properly. Pin 1 of the plug
connects to the orange wire. Ensure this is aligned to Pin 1 of the locomotive. If the plug is installed
wrong way round the lights will not work.
When installing the plug ensure that the pins are not bent or broken.
27
E