General Safety; Operating The Device Safely - Dometic Waeco CoolMatic CS-MP2 Instructions De Montage Et De Service

_CS-ACT-MP2.book Seite 17 Freitag, 15. Oktober 2010 10:55 10
CoolMatic CS-MP2
2.1

General safety

Caution - danger of electrocution
Check that the voltage specification on the type plate
corresponds to that of the energy supply.
Only connect the device to 12/24 V
If the connection cable is damaged, it must be replaced to
prevent possible electrical hazards.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick
charging device. Overvoltage can damage the electronics of the
device.
Do not operate the device if it is visibly damaged.
This appliance may only be repaired by qualified personnel.
Improper repairs can lead to considerable hazards.
Should your device need to be repaired, please contact
WAECO customer services.
Do not open the refrigerant circuit under any circumstances!
The cooler is not suitable for transporting caustic materials or
materials containing solvents.
Food may only be stored in its original packaging or in suitable
containers.
2.2

Operating the device safely

In order to work properly, the cooler must have been standing
upright for at least an hour before you switch it on.
The cooler has a built-in inclination sensor which switches it off
when it is tilted. Nevertheless, always switch off the cooler
before tilting the cab.
Before switching the cooler on again, let it stand for at least
15 minutes after lowering the cab.
Do not place any electrical devices inside the cooler.
Install the device in a dry location where it is protected against
splashing water.
Do not install the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.)
Safety instructions
.
DC
17