Technical Data; Declaration Of Conformity - Bosch GDS 24 Professional Notice Originale

Technical Data

Impact Wrench
Article number
Rated power input
Output power
No-load speed
Max. torque for hard/soft screwdriving application
according to ISO 5393
Right/left rotation
Max. screw dia.
Tool holder
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
30.10.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
GDS 24
Professional
0 601 434 1..
W
W
rpm
Nm 600/300
kg
Assembly
Changing the Tool
Before any work on the machine itself, pull
the mains plug.
When working with an application tool, pay
attention that the application tool is firmly
seated on the tool holder. When the applica-
tion tool is not firmly connected with the tool
holder, it can come loose again and not be
controlled.
Slide the application tool 7 onto the square drive
of the tool holder 6.
English | 15
GDS 30
Professional
0 601 435 1..
800
400
1260
1000/500
M 24
¾ "
5.7
/ II
1 609 929 M73 | (24.10.07)
920
500
1260
M 30
1"
7.3
/ II