Assembly - AL-KO solo Mode D'emploi

ASSEMBLY

The following assembly work must be carried out before the first
operation:
1. Installation of the steering wheel.
2. Installation of the driver's seat.
3. Assembly of the discharge flap on the blades
Attention!
Putting into operation (even test operation) before complete
assembly is strictly forbidden - dangers of accidents!
The information on directions (right, left, top etc.) for this appliance
are to be understood in the direction of travel looking from the dri-
ver's seat.
The order of assembly steps is to be complied with, as otherwise
flawless function cannot be guaranteed.
Please note:
The figures stated to the left of the text, such as the
here, refer to the illustrations in the illustrated part at
the front.
Assembly of the steering wheel
1
Align front wheels (a) straight ahead in the direction of tra-
vel.
Fit clamping sleeve (b) on steering column.
Place steering wheel (c) on clamping sleeve.
Observe position: Spoke must point towards driver.
Insert washer (d).
Push toothed lock washer (e) onto hexagon bolt (f).
Secure steering wheel with hexagon bolt.
Observe correct tightening torque: 20 Nm
Push on cover (g).
Installing the driver's seat
2 Unscrew the driver's seal according to the diagram on the
hinged console.
Hexagonal recess hole screw M8 x 20
Fan-disk Ø 8.4 x Ø 15
Disk Ø 8.4 x Ø 24
Spacer bushing Ø 8.2 x Ø 14
Hexagonal recess hole screw /
Wing screw M8 x 20
Fan-disk Ø 8.4 x Ø 15
Push the seat into the required position and tighten the scr-
ews by means of the enclosed socket wrench - 6 mm (Allen
key)!
The seat can be moved in a longitudinal direction by loose-
ning the screw .
GB
Assembly of the discharge flap on the bla-
des
3
Position the discharge flap on the blades.
4
Push the holding bar through the flaps of the discharge flap,
the blades and the spring. Keep the spring pressed down
while doing this.
5
Shift the holding bar as securing and allow it to engage on
the discharge flap.
The cutting gear may only be put into operation if the
discharge flap has been fitted correctly. Defective
discharge flaps must be replaced by original spare parts
without delay.
5
(2 x)
(2 x)
(2 x)
(2 x)
(2 x)
(2 x)
GB8