Product Overview; Description Of Function; Sensors; Transformer - AL-KO EasyMow 700 Mode D'emploi

en

PRODUCT OVERVIEW

The product overview (2) provides an overview of
the machine.
2-1 Operating panel (under cover flap)
2-2 Charging contacts
2-3 Bumper
2-4 Deck
2-5 Cover plate (flap for height adjustment)
2-6 Height adjustment interior
2-7 STOP key
2-8 Front rollers (steering)
2-9 Blade plate
2-10 Drive wheels
2-11 Cutting blade
2-12 Clearer blade

DESCRIPTION OF FUNCTION

The robotic lawn mower is a fully automatic,
battery-operated lawn mower which moves
freely within a defined mowing area.
The mowing area is defined by a boundary
cable that is connected to the base station.
In order for its battery to be recharged, the ro-
botic lawn mower moves along the boundary
cable into the base station.
Mowing programs are pre-installed for mo-
wing, and also include the lawn and edge mo-
wing function. These mowing programs can
be changed.
The special arrangement of blades means
that the mown grass is not gathered up but
remains on the lawn between the stalks of
grass. As a result, it has a mulching or fertili-
sing effect.

SENSORS

The robotic lawn mower is equipped with various
safety sensors (9).
Lifting sensor
If the robotic lawn mower is lifted up by its
deck during operation, a sensor stops the
blade within 2 seconds and switches off the
travel drive.
28
Bump sensors and obstacle detection
The robotic lawn mower is equipped with sen-
sors that ensure it changes its direction of
travel if it encounters obstacles. When it en-
counters an obstacle, the top part of the deck
(9-1) is shifted slightly. This causes a sensor
to trigger a change in the direction of travel.
Tilt sensor in direction of travel
The robotic lawn mower is switched off by the
tilt sensor if it encounters an upward or down-
ward slope of more than 35%.
Tilt sensor on side
The robotic lawn mower is switched off by the
tilt sensor if it encounters sideways slopes of
more than 35%.
The robotic lawn mower does not re-
start automatically after being switched
off by a safety sensor. To restart, it is
necessary to acknowledge the fault by
pressing the multifunction key and rec-
tifying the fault.

TRANSFORMER

The transformer generates the electricity for the
base station.
WARNING!
Damage due to splash water!
Set up the transformer in a dry place
where it is protected against splash wa-
ter.
We recommend the connection via a
earth leakage circuit breaker (ELCB)
with a rated leakage current < 30 mA!

ASSEMBLY

It is essential to comply with the se-
quence described here
CAUTION!
Danger - risk of injury!
Always ensure stability when working!
Wear work clothing and protective gear.
Product overview
Robotic lawn mower