Overview Of Main Menu; Program Menu - AL-KO EasyMow 700 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en
1
Use the corresponding [arrow keys] (3-3) to
select the corresponding digits and confirm
each one with the [multifunction key] (3-5).
Following this, the LCD display (3-1)
shows the [Uncalibrated] status window.
Calibration
For calibration, set up the robotic lawn mower ac-
cordingly (12-3).
13.06.2013
! Warning !
Drive starts
Charge 80%
1
The automatic calibration procedure starts
when the [START key] (3-4) is pressed.
The [Drive starting] warning flashes on
the LCD display (3-1).
CAUTION!
The drive starts when the [START key]
is pressed.
Do not reach into rotating parts.
Calibration procedure
The robotic lawn mower first moves straight over
the boundary cable in order to gauge the signal
strength, and then into the base station. The bat-
tery of the robotic lawn mower is charged.
The robotic lawn mower must remain
stopped when it moves into the base sta-
tion. If the robotic lawn mower does not
meet the contacts when it moves into the
base station, it will move further along
the boundary cable until it meets the con-
tacts or the procedure is cancelled.
Display after the calibration movement
The mowing window preset at the factory is dis-
played after calibration.
The mowing program is active, the battery is
charged.
After calibration has been completed, the robo-
tic lawn mower can be used for mowing with
the factory-set mowing times without further pro-
gramming.
The following mowing times are factory-set: Mon
- Fri: 07:00 - 10:00 and Mon - Fri: 17:00 - 19:00.
32

OVERVIEW OF MAIN MENU

The following menu items can be selected:
12:15
Main
menu

PROGRAM MENU

Observe local ordinances regarding opera-
ting times.
Programs
Settings
Information
Press menu key [3-8] to open the main menu.
Select the required program item with the [ar-
row keys] (3-3) and confirm with the [multi-
function key right] (3-5).
Each menu can be exited using the menu
keys [3-8].
Make the settings in the week program.
Look at the program info, e.g. mowing pro-
gram.
Start-up
Week program
Entry points
Program info
Time
Date
Language
PIN code
Button tones
Edge mowing
Display contrast
Recalibrate
Factory settings
Hardware
Software
Program info
Faults
Robotic lawn mower

Publicité

Table des Matières
loading

Table des Matières