Intended Use Of This Power Tool; Prohibited Use Of This Power Tool; Safety Precautions; Electrical Safety - Evolution R255 SMS Notice Originale

www.evolutionpowertools.com

INTENDED USE OF THIS POWER TOOL

WARNING: This product is a Multi-material
sliding miter saw and has been designed to be
used with genuine Evolution blades rated for
this machine. Only use blades designed for use
in this machine and/or those recommended
specifically by Evolution Power Tools Ltd.
When fitted with a correct blade this
machine can be used to cut:
• Wood, Wood derived products
(MDF, Chipboard, Plywood, Block-board,
Hardboard, etc),
• Wood with nails,
• 2" mild steel box section with 1/8" wall at HB
200-220,
• 1/4" mild steel plate at HB 200-220.
Note: Wood containing non-galvanised nails
or screws, with care, can be safely cut.
Note: Not recommended for cutting
galvanised materials or wood with embedded
galvanised nails.
PROHIBITED USE
OF THIS POWER TOOL
WARNING: This product is a Multi-material
sliding miter saw and must only be used as
such. It must not be modified in any way,
or used to power any other equipment or
drive any other accessories other than those
mentioned in this Instruction Manual.
WARNING: This product is not
(1.13)
intended for use by persons (including
children) with reduced physical, sensory or
mental capabilities, or lack of experience
and knowledge, unless they have been
given supervision or instruction concerning
the safe use of the product by a person
responsible for their safety and who is
competent in its safe use.

SAFETY PRECAUTIONS

ELECTRICAL SAFETY

(1.14)
This machine is fitted with the correct moulded
plug and mains lead for the designated market.
If the supply cord is damaged, it must be
replaced by a special cord or assembly available
from the manufacturers or its service agent.

OUTDOOR USE

(1.15)
WARNING: For your protection if this tool
is to be used outdoors it should not be
exposed to rain, or used in damp locations.
Do not place the tool on damp surfaces.
Use a clean, dry workbench if available. For
added protection use a residual current
device (R.C.D.) that will interrupt the supply
if the leakage current to earth exceeds
30mA for 30ms. Always check the operation
of the residual current device (R.C.D.)
before using the machine. If an extension
cable is required it must be a suitable
type for use outdoors and so labelled.
The manufacturers instructions should be
followed when using an extension cable.
GENERAL POWER TOOL
(2.1)
SAFETY INSTRUCTIONS
WARNING: When using electric tools basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
personal injury including the following.
Note: This power tool should not be powered on
continuously for a long time.
WARNING: Read all safety warnings and
instructions before attempting to operate this
product and save these instructions. Failure to
follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
Save All Warnings & Instructions
For Future Reference
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
1) General Power Tool Safety Warnings
(2.2)
[Work area safety]
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gasses or dust. Power tools
create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating power tool. Distractions can cause
you to lose control.
d) Do not use this machine in an enclosed
room.
5
EN
FR
(CA)
ES
(LA)