Machine Specifications - Evolution R255 SMS Notice Originale

MACHINE SPECIFICATIONS

Motor (120V ~ 60 Hz)
Speed No Load
Weight (Net)
Dust Port Diameter
Tool Dimensions (H x W x L) (0° / 0°)
(Note: Dimensions taken with saw head down.)
Cable Length
Mild Steel Plate - Max Thickness
Mild Steel Square Tube - Max Wall Thickness
(2" mild steel Square Tube)
Wood – Max section
Minimum size work-piece
(Note: Any work-piece smaller than the recommended minimum
work-piece requires additional support before cutting.)
MAXIMUM CUTTING ANGLES
Miter
Bevel
MITER
0°
0°
45°
45°
50˚
50˚
Diameter
Arbor / Bore
Thickness
Laser Class
Laser Source
Laser Output Power (Max)
Wave Length (Nm)
WARNING: Due to the power input of this product on start up, voltage drops may occur and this
can influence other equipment (e.g. dimming lights). So for technical reasons we advise, if the
mains-impedance is Zmax<0.318 Ohm, these disturbances are not expected. If you require further
clarification, you may contact your local power supply authority.
MACHINE
14- 3/16" x 27-3/4" x 28-47/64"
CUTTING CAPACITIES
L: 8-1/2" x W: 2-3/4" x D: 1/8"
LEFT
50˚
0˚ - 45˚
BEVEL MAX WIDTH
0° 11-13/16"
45° 8-1/4"
0° 11-13/16"
45° 8-1/4"
0˚ 7-9/16"
45˚ 7-9/16"
BLADE DIMENSIONS
LASER
4
www.evolutionpowertools.com
15 A
2500 rpm
36 lb
1 -3/8"
10ft
1/4"
1/8"
11-3/4 x 3-9/16"
RIGHT
50˚
N/A
MAX DEPTH
3-9/16"
3-9/16"
2"
2"
3-1/2"
1-3/4"
10"
1"
0-5/64"
Class 2
Laser Diode
≤1mW
650