Technical Information - AEG GS60AV221 Notice D'utilisation

78 www.aeg.com
Problem
Whitish streaks and
stains or bluish lay-
ers on glasses and
dishes.
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
Possible cause
The set level of the water
softener is incorrect.
The cap of the salt contain-
er is loose.
The released quantity of
rinse aid is too much.
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
• The programme had no
drying phase.
• The programme had a
low temperature drying
phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Possible solution
Make sure that the set level
of the water softener agrees
with the water hardness in
your area.
Tighten the cap.
Decrease the released quan-
tity of rinse aid .
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
For better drying results,
keep the door ajar for some
minutes.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
220-240 V
50 Hz
max. 60 °C
12