AEG GS60AV221 Notice D'utilisation page 77

Problem
The appliance does
not drain the water.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
THE WASHING RESULTS AND DRYING RESULTS ARE NOT
SATISFACTORY
Problem
The dishes are not
clean.
Limescale particles
on the dishes.
Possible cause
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
Possible cause
The filters are clogged.
The filters are not correctly
assembled and installed.
The spray arms are clog-
ged.
The programme was not
applicable for the type of
load and soil.
Incorrect position of the
items in the baskets. Water
could not wash all items.
The spray arms could not
turn freely.
The quantity of detergent
was not sufficient.
There was no detergent in
the detergent dispenser.
The salt container is empty.
Possible solution
Clean the sink spigot.
Make sure that the position
of the hose is correct.
If other alarm codes show, contact the
Service.
Possible solution
Clean the filters.
Make sure that the filters are
correctly assembled and in-
stalled.
Remove remaining soil with a
thin pointed object.
Make sure that the pro-
gramme is applicable for the
type of load and soil.
Make sure that the position
of the items in the baskets is
correct and that the water
can easily wash all items.
Make sure that the position
of the items in the baskets is
correct and does not cause
the blockage of the spray
arms.
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Make sure that you add de-
tergent in the dispenser be-
fore you start a programme.
Make sure that there is dish-
washer salt in the salt con-
tainer.
ENGLISH
77