Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ARF868 Radio Modems - User guide version V1.6
3. Data exchange – Communication mode
Principe :
The communication mode is the default mode.
On switching on the modem is configured in RS232, 9.6kbps (serial link), 2.4kbps (RF data rate).
By default, the modem is in permanent listening mode of the RF interface and the UART port.
•
As soon as a frame from the RF link is demodulated, its content is transmitted to the UART port
•
As soon as a character chain is detected on the UART port, it is transmitted to the RF link.
"Air" communication takes place according to the following choice of protocols:
•
Continuous asynchronous (default mode)
•
"Legacy X3Pro" continuous asynchronous
3.1. Continuous asynchronous protocol
3.1.1 Description of the protocol
The continuous asynchronous protocol enables data transfer from the UART interface to the radio link with the lowest possible latency. It is
associated with radio modulations enabling a wide range of air data rate and ranges to be covered. This is the mode that will allow you to use
the ARF868 modem to the maximum of its possibilities.
•
In transmission, data entering on the UART is immediately transmitted into the "air".
•
In reception, data from the RF frames is transmitted progressively to the UART interface.
There is no buffering of complete radio frames before or after transmission on the serial link.
However, the product has buffering enabling a buffer to be performed if the radio and UART data rates are different. The UART interface does
not require a specific protocol. Each octet transmitted is transferred into the air and vice versa.
Thanks to its low latency and the absence of a protocol on the UART port, the ARF868 modem used with the continuous asynchronous protocol
is completely transparent in the replacement of a wire link.
3.1.2 Implementation
The continuous asynchronous protocol is selected by the S222 register (cf §5.3).
It can use the following radio data rates: 2.4kbps, 9.6kbps, 38.4kbps and 57.6kbps. The adjustment of the radio data rate is done via the S254
register (cf § 5.3).
The notions of addressing (broadcast communication, group communication and addressed communication between products) are available and
described below.
3.1.3 Addressing
The product has various addressing modes that are configurable via the product registers. The following modes are available:
•
Transparent mode without sub-network
•
Transparent mode with sub-network
•
Addressed mode without sub-network
•
Addressed mode with sub-network
The transparent modes are intended for inter-product communication: all products are recipients of the frames transmitted. The addressed
modes enable communication to one or more products (creation of sub-groups).
Transparent mode without sub-network
•
In the Transparent mode without sub-network all products within range receive the frames from the transmitting products. The configura-
tion required for this mode of communication is as follows :
•
S220=0 (transparent mode)
•
S253=0 (no group)
Page
16
of 25
Publicité
Chapitres
Table des Matières
