Electrical Connections; Electrical Data - AERMEC ANR Série Notice D'installation Et De Maintenance

Masquer les pouces

Table des Matières

Les langues disponibles

All the electrical opera-

tions must be carried

out by PERSONNEL IN

POSSESSION OF THE

NECESSARY

FICATIONS BY LAW,

suitably trained and

informed on the risks

related to these opera-

tions

The ANR heat pumps are completely wi-

red at the factory and only require con-

nection to the electrical mains. Please

verify that the characteristics of your

electrical mains are suitable for the ab-

sorption values indicated in the table of

electrical data, taking into consideration

any other machines operating at the

same time.

8. 1 ELECTRICAL DATA

Power supply

Model

ANR 0502H

ANR 0802H

ANR 0902H

ANR 0502HM

ANR 0802HM

ANR 0902HM

ANR 0502HP

ANR 0802HP

ANR 0902HP

ANR 0502 HA

ANR 0802HA

ANR 0902HA

ANR 0502 HK

ANR 0802 HK

ANR 0902 HK

ANR 0502 HKM

ANR 0802 HKM

ANR 0902 HKM

NOTE:

Check the tightening of all the terminals

of the power conductors at the first

start-up and after 30 days from the

start of service. Subsequently, check

the tightening of all the power termi-

nals every six months.

Loose terminals can cause overheating

of the cables and components.

The

characteristics

of the electrical lines and

of the related components

must be determined by

QUALI-

PERSONNEL

TO DESIGN ELECTRICAL

SYSTEMS, in compliance

with the international and

national regulations of the

place of installation of the

unit and in compliance with

the regulations in force at

the moment of installation.

LINES AND ELECTRICAL DATA OF THE

UNIT

NOTE

The connection cables are not provided

with the unit.

The cross-sections of the cables shown

in Table 17. 1 . 1 are recommended for a

maximum length of 50 m. For greater

lengths, the PLANT ENGINEER is respon-

Recommend line

voltage

cross-section (A)

400V 3N

2,5

400V 3N

230V

400V 3N

230V