Maintenance - Ego Power+ HT2410 Guide D'utilisation

MAINTENANCE

WARNING:
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING:
from the product when cleaning or performing any maintenance.
CLEANING
 Use a soft brush to remove debris from all air intakes and cutting blade.
 To remove pitch and other sticky residue, spray the blades with resin solvent.
Run the motor briefly so that the solvent is evenly distributed.
 Wipe the surface with a dry cloth.
WARNING:
cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents. Use a clean cloth to remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING
BLADE
1. Start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig. 9. This
will allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from your
hedge trimmer.
3. Clamp the blade assembly in a vise
and file the exposed cutting surface of each blade tooth. Remove as little material as
possible. Be sure to retain the original angle of each tooth when filing.
4. Remove the hedge trimmer from the vise; restart it and stop it to expose the
unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2410/HT2410-FC
When servicing, use only identical replacement parts. Use of any
To avoid serious personal injury, always remove the battery pack
Never use water to clean your trimmer. Avoid using solvents when
9
Cutter Tooth
Guard Tooth
21