Christopeit Sport TM800S Notice De Montage Et D'utilisation page 21

Pulse measurement function
Embrace with both hands, the hand pulse sensors on the computer to
order a pulse measurement can be performed. Alternatively use a compa-
tible chest belt (un -coded with transmission
frequency from 5.0-5,5kHz). The measured pulse value appear in the pulse
display. Caution: The pulse measurement is not suitable for medical pur-
poses.
Function of safety clip
The safety clip has an emergency function. In fear or danger or if you fall
down or jumped from it, the safety clip will lose position at computer and
stops the motor with break system. Put the safety key out from computer
on any status, the display is „---", the buzzer beep each second. Put the
safety key on computer, then the display will enter normal manual mode.
All parameter reset to zero.
Meanings of error message codes
In case of malfunctions may adjoining list of error messages help for peo-
ple to get function back. Basically, electrical repairs only in compliance
with the relevant safety rules which exists. For more information and assi-
stance in case of malfunctions with our service department (contact details
see last page.)
Problem Potential reasons
---- Safe lock falls down
E01 Communication error
E02 Motor cable
Improperly connected
E03 Speed signal error
E05 Overload Protection
E06 Undervoltage protection
Training area in mm
(for home trainer and user)
Hibernation
If the treadmill stays in standby model for more than 10 mins, it will hiber-
nate.
Km / Miles – Switching
If you remove the safety clip and press the
neously for 3 seconds, you will hear a beep and the screen will display the
maximum speed for both units (16 for km/h or 10 for m/h).
Solutions
Place back the safe lock.
Check to see if communication cable properly connected or damaged
Check to see if motor cable properly connected.
Check if the controller smells peculiar, if so replace the controller.
Check if speed sensor properly connected, reconnect if necessary.
Check if speed sensor properly fixed or damaged, re-fix or replace if
necessary.
Check if motor is damaged and replace accordingly.
Overload or treadmill jam will result in an overload protection. Check if
motor running with an overload sound or burnt smell and replace the
motor or controller.
Check if rated voltage is in accordance with the treadmill and use the
correct rated voltage to power the treadmill
Check if there is a low voltage lower than 50% of normal voltage. If so
please operate in a higher voltage environment.
Check if controller smells peculiar, if so replace the controller
Free area in mm
(Training area and security area
(rotating 60cm))
21
and buttons simulta-