Christopeit Sport TM800S Notice De Montage Et D'utilisation page 19

Function of Displays:
1. - Shows how long you have been running in minutes and
seconds in the normal model or remaining time in the countdown
model.
2. - Shows how far you have run in kilometers in the normal
model and remaining distance in the countdown model
3. - Displays the speed of the treadmill in kilometers per
hour, or the heart rate, when your hands touch the pulse sensors.
4. - Displays the Kilocalories consumed in kcal.
Function of keys:
[start] - Key
Press Start-key to start exercise program (motor starts running).
This key is also located on the pulse handles.
[stop] - Key
Press [stop]-key during exercise to interrupt the program (motor
stops running). Within 5 min. you can press [start]-Key to continue
this exercise program or press [stop] - key again to finish this pro-
gram. Pre-values can set to zero by pressing the [stop] - key. This
key is also located on the pulse handles.
- Key: (Function)
Select key of time-program H-1, distance program H-2 or calories
program H-3.
- Key: (Program)
Press this key to select exercising speed programs Manual/ P1-
P14 / U1-U3 / HR1- HR3 / FAT
- Key:
Press speed up key increase settings or motor speed. This key is
also located on the pulse handles.
- Key:
Press speed down key decrease settings or motor speed. This key
is also located on the pulse handles.
Quick Speed- keys 2, 4, 6, 8, 10 and 12km/h:
Press one of these keys and the speed changes direct into 2, 4, 6,
8, 10 and 12 km/h.
User manual of Computer
Manual
How to start manual mode:
Put in the AC plug in wall power 230V~50Hz and put on the power
switch. Put safety clip onto the computer and it will show normal
manual mode. Stand your feet on both side rails. Put the safety
key at you exercise cloth and press start-key to start with exer-
cising. After a 3 sec. count down, the motor begin to run slowly
and you can step on the running belt and follow the speed. Adjust
the speed with
fety clip from computer at any time, the motor stop slowly and the
display will show „---". After put on the safety key on computer the
normal manually program will show. Press
value of speed. Press quick speed - key to adjust speed quickly.
All values of the displays will counter up.
Time Program (H1):
On the normal manual mode, press
gram H-1. The time display will flash and the initial value is 15:00.
Press
the display counts up till zero and then stops running motor.
Distance-Program (H2):
On the normal manual mode, press
program H-2. The distance display will flash and the initial value
is 1,00KM. Press
99:90KM. If set a value the display counts up till zero and then
stops running motor.
KCalories-Program (H3):
On the normal manual mode, press
gram H-3. The calories display will flash and the initial value is 50,0
kcal. Press
If set a value the display counts up till zero and then stops running
motor.
If you have not set anything, the value is automatically increased
to the maximum and restarted. In the manual program, the tread-
mill turns off automatically after 99:59 minutes.
19
/
keys into desired speed. If put off the sa-
key to set value. The range is: 5:00-99:00. If set a value
/
key to set value. The range is: 0,50-
/
key to set value. The range is: 10- 999kcal.
/
key to adjust
key, to enter time pro-
key, to enter distance
key, to enter calories pro-