Chain Bucket; Service And Maintenance; General Regulations For Service And Maintenance Work - Tractel Tralift TS Série Instructions D'emploi Et D'entretien

2.2.4 Chain bucket

Move chain out at load side until limit switch is activated
Attach free end of chain to housing (see chapter 2.2.2)
Attach chain bucket and allow chain to run in (see figure 2-13)
DANGER !
All steel plate chain buckets must be equipped with an additional wire cable with a minimum diameter of 2 mm (see figure 2-14).
Figure 2-13

3 Service and maintenance

Operating failures in electric chain hoists affecting the safe operation of the device should be remedied immediately.

3.1 General regulations for service and maintenance work

CAUTION !
Maintenance and repair work on the electric chain hoist may only be carried out by qualified and trained personnel.
CAUTION !
If the operator performs maintenance work on an electric chain hoist on his own account, the type of maintenance performed together
with the date carried out must be entered in the log book.
Alterations to, as well as modifications and supplements to electric chain hoists which may affect safety must be authorized by the manufacturer in
advance. Structural alterations to chain hoists not authorized by the manufacturer exempt the manufacturer from liability in case of damage.
Material warranty claims will only be recognized if solely manufacturer's genuine spare parts have been used.
We explicitly wish to point out that those original parts and accessories not supplied on our behalf cannot be inspected or released by us.
Figure 2-14
... kg
15