Load Chain - Tractel Tralift TS Série Instructions D'emploi Et D'entretien

DANGER !
The protective conductor should not carry any power. With motor carriage operation, the power supply is enclosed in a terminal box of
the drive motor. With the installation of a motor protector, the load plate voltage of the electric chain hoist must be observed.
CAUTION !
Checking direction of rotation: If the direction of rotation does not correspond to the button symbols on the control switch, power
supply wires L1 and L2 must be swapped round
Inching operations on single-phase models can cause interference
NOTE
Open the terminal that is used in
accordance with figure 2-4.

2.2.2 Load chain

CAUTION !
Only use original chains
Welded seam of the chain links must face inward on the chain wheel (see figure 2-5)
The gearbox limit switch must be mechanically disabled in order to pull in the chain, see chapter 2.2.3
Before start-up and during operation the load chain must be oiled along its full length. Oil must constantly be present on the internal, contacting
and rubbing surfaces of the chain links. Lubrication is carried out by submersion or with an oil can, using a creeping gear oil.
The end of the chain should be attached to a flexible piece of wire (1) and fed through the chain wheel (2) of the electric chain hoist. Through short
switching impulses, the chain (3) will be housed correctly in accordance with figure 2-5.
The lifting height must be adjusted such that the hook fittings lie on the ground in the lowest hook position.
Figure 2-5
1
12
Figure 2-4
8-9 mm
2
3