regulations. Repairs are to be carried out only by a
qualified electrician using original replacement parts
or the user may suffer an accident.
•
If necessary, wear suitable personal protection equip-
ment. This could consist of:
-
Ear plugs to prevent the risk of damaging your hear-
ing;
-
A breathing mask to avoid the risk of inhaling hazard-
ous dust.
-
Always wear gloves when handling saw blades and
rough materials. Whenever practicable, saw blades
must be carried in a container.
•
The operator must be informed about the conditions
that influence the generation of noise (for example
saw blades designed to reduce noise emissions, car-
ing for blades and the machine).
•
Faults on the machine or its guards, safety devices
and blade must be reported to the person in charge
as soon as they are discovered.
•
Use only the transport devices to move the machine.
Never use the guards for handling and moving the
machine.
•
All operators must receive proper training in the use,
adjustment and operation of the machine.
•
Do not saw any materials that contain foreign bodies
such as wires, cables or ties.
•
Only use sharp saw blades
•
The machine must stand during the operation on a
horizontal , flat floor and the floor around the machine
must be level, well maintained and free of debris,
such as Be chips and cut workpieces.
•
Assign the workpiece to be machined and the stack
finished workpieces close to the normal work of the
operator.
•
Make it adopt the safe procedures for cleaning, main-
tenance and the regular removal of chips and dust
to avoid the risk of fire .
•
Follow the instructions of the manufacturer for use ,
adjustment and repair of saw blades.
•
Note appearing on the blades maximum speed.
•
Make sure that the flanges used are as specified by
the manufacturer , suitable for the intended use .
•
Make sure you include that necessary for operat-
ing the machine guards and other safety devices
are fitted, they are in good operating condition and
properly maintained .
•
The dust level is influenced by the type of material
to be cut
15