Appendix; Mastercool Appliances - Miele RemoteVision XKM 2000 WLAN Instructions D'installation

MasterCool Appliances

RemoteVision module
installation
Always disconnect the appliance
from the power supply when
performing installation, maintenance
or service work.
Install the RemoteVision module
before placing the appliance in its
installation niche.
The slot for the RemoteVision module is
located in the lower area of the back of
your appliance.
^ Unscrew the screws a on the cover
and pull off the sticker b.
^ Remove the cover.
^ Push the module into the WLAN slot
until it snaps into place.
^ Connect the appliance to the power
supply and turn it on. After several
seconds the indicator light will come
on.
The indicator light will display different
colors one after the other; any control
light at the end indicates that the
module was correctly installed.
If the indicator light does not come on,
installation of the module was
unsuccessful. In that case, repeat the
process. If that does not correct the
problem, contact Miele.
^ Pull the antenna straight out.
^ Guide the cover over the antenna
and screw on the cover.
^ Angle the antenna so that it faces to
the right or left.
^ If necessary, disconnect the power
supply and continue installing the
appliance.

Appendix

31