Locomotive Settings; Cv- List For The Br 03.10 - Roco BR 03.10 DR Manuel

▪ Locomotive Settings

The Sounddecoder has been optimally adjusted to this locomotive. You can still adapt numerous
decoder properties to your wishes however. Certain parameters (referred to as CVs – Configu-
ration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in
the decoder not reacting correctly.
The decoder is preprogrammed with 128/28 speed steps at the factory for a high level of com-
fort. This means that it can be used together with all of the modern DCC (MULTIMAUS
Motorola control devices.
2)
The Sounddecoder has been especially modified for the additional functions and must
not be replaced with a decoder which is available from a retailer.
If the locomotive is to be reprogrammed, only the locomotive is to be on the program-
ming track.
▪ CV-Liste of the BR 03.10
CV Name
1 Address (= short address)
2 Minimum speed (lowest creeping speed)
3 Start-up delay (from standstill to maximum speed)
4 Braking delay (from maximum speed to stand-still)
5 Maximum speed
6 Medium speed (at medium running step)
Value 1 corresponds to 1/3 of Vmax. (CV 5)
7 Decoder Version Number (only read! Readable only on
reading-capable amplifiers/centres).
Important! Please note when using the MULTIMAUS
in order to achieve CVs greater than CV255: when un-
dertaking a short-term programming of CV7, only the
subsequent programming access with the value 10 is
increased by 100 CV places (meaning CV166 then ac-
cesses CV266 for example). The value 20 is increased
by 200 CV places.
8 Resetting of all values to the default settings; (With
readable amplifiers/controllers, the manufacturer ID is
readable)
8072183920.indd 29
Value Default
Value
01 – 99
01 – 252
00 – 255
00 – 255
00 – 252
00 – 252
®
08 = Reset
) and
®
3
8
40
40
170
70
29
29
06.09.2017 13:47:57