Locomotive Settings - Roco 23 Serie Manuel

▪ Locomotive Settings

The Sounddecoder has been optimally adjusted to this locomotive. You can still adapt numerous decoder properties to your wishes however.
Certain parameters (referred to as CVs – Configuration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in the decoder not reacting correctly.
The decoder is preprogrammed with 128/28 speed steps at the factory for a high level of comfort. This means that it can be used together with
all of the modern DCC (MULTIMAUS®) and Motorola
The Sounddecoder has been especially modified for the additional functions and must not be
replaced with a decoder which is available from a retailer.
If the locomotive is to be reprogrammed, only the locomotive is to be on the programming track.
▪ CV-List of the BR 23
CV Name
1 Address (= short address)
2 Minimum speed (lowest creeping speed)
3 Start-up delay (from standstill to maximum speed)
4 Braking delay (from maximum speed to stand-still)
5 Maximum speed
control devices.
®
Value Default Value
01 – 99 3
01 – 252 10
00 – 255 35
00 – 255 17
00 – 252 200
43