Residual Heat Indicator; Main Power Switch; Setting The Cooktop - Thermador MASTERPIECE Série Mode D'emploi

The Elements
Element
$
Single element
ð
Dual element
ò
Triple element

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
•
If an is shown on the display, the element is still hot.
You could use it, for example, to keep a small quantity of
Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the ON/OFF key until the
Turning the cooktop off
Touch the ON/OFF key until the
heat indicators will remain on until the elements have
cooled off sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the elements
have cooled down sufficiently.
the corresponding element symbol.
10
Turning on and off
Single elements have only one size cooking surface. Always use cook-
ware of a suitable size.
The size of these elements can be matched to your pan size. The heat-
ing element must be turned on.
Turning off the outer heating ring: Touch PAN SIZE. The
will turn off.
Adding: Touch PAN SIZE again. The
On this element you can turn the medium and large heating rings off.
The heating element must be turned on.
Turning off the outer heating ring: Touch PAN SIZE. The
will turn off.
Turning off the middle heating ring: Touch PAN SIZE again. The
display will turn off.
When you turn the heating element on again, all of the heating rings
will be on.
"
indicator turns on.
"
turns off. The residual
• œ
/ is displayed next to
ð
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number
keys 1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
†
indicated by . and is set using
ð
display
display will turn on.
ò
display
œ
. The display
@ A
and .
ð