4.6.1. PLACING THE SYSTEM IN SHIPPING MODE
If you intend to wake up the system from Shipping Mode
there are two ways of doing this:
•
Connect the system to a computer via USB, start up
the software downloaded from the DAINESE website
and start the Shipping Mode procedure, disconnect
the USB cable from the system.
•
With the system switched on and not charging, press
and hold the recovery button on the side of the USB
connector for 3 seconds.
Make sure that shipping mode has been correctly set by
closing the switch-on button and checking that the system
does not switch on.
WARNING!
With the system in Shipping Mode it is not possible to
switch on the system using the switch-on/switch-off
button.
70
I N F O R M A T I V E
N O T E
F O R
I N F L A T A B L E
4.6.2. WAKING UP THE SYSTEM FROM SHIPPING MODE
If you intend to wake up the system from Shipping Mode
there are two ways of doing this:
•
Start charging the system via USB;
•
Press the recovery button at the side of the USB
connector once.
WARNING!
With the system in Shipping Mode it is not possible to
switch on the system using the switch-on/switch-off
button.
P R O T E C T O R S
4.7. CHANGE OF OWNERSHIP
If you intend to sell your D-AIR STREET SMART JKT to a
third party, you must inform DAINESE in advance, so that
it can record the new owner's data. For this reason, please
contact the DAINESE Technical Assistance service indicated
at the foot of this Informative Note, providing the information
TABLE 7: CUSTOMER INFORMATION FOR CHANGE OF OWNERSHIP
NEW OWNER
FIRST NAME:
SURNAME:
ADDRESS:
CITY:
NATION:
TEL:
E-MAIL:
indicated in Table 7.
WARNING!
To
ensure
correct
traceability
for
any
updates/
communications/recalls, you must inform DAINESE in advance
of any change of ownership of the D-AIR STREET SMART JKT.
FORMER OWNER
FIRST NAME:
SURNAME:
ADDRESS:
CITY:
NATION:
TEL:
E-MAIL:
D-AIR CODE:
ON THE LABEL OF THE D-AIR STREET SMART JKT
D - A I R ®
S T R E E T
S M A R T
J K T
71