Guide To User Interface Led Sequence During Use - DAINESE D-AIR STREET SMART JKT.1 Notice D'utilisation

3.5. GUIDE TO USER INTERFACE LED SEQUENCE
DURING USE
The user interface is formed of a multicolour LED and a VIBRAMOTOR positioned on a specific part of the front left side of the
garment into which the D-AIR STREET SMART JKT is integrated (see diagram of the system in Fig. 10). Possible colours are:
red, yellow, green and blue. The VIBRAMOTOR vibrates when the red LED switches on.
48 I N F O R M A T I V E N O T E F O R I N F L A T A B L E P R O T E C T O R S
1
After closing the switch-on/switch-off button positioned on the chest strip and thus switching on the System, the
interface will show a Red, Green, Yellow and Blue sequence of LEDS to indicate that the interface is operating correctly.
If the colors displayed are not correct, contact the Dainese Technical Assistance Service or an authorized Dainese dealer.
The VIBRAMOTOR will vibrate once, for one second, when the red light switches on.
1 1
X X
FIGURE 10: EXAMPLE OF THE INTERFACE VERIFICATION SEQUENCE
WARNING!
Before using the D-AIR STREET SMART JKT always make sure that, upon switching on, the interface is communicating
correctly by checking the Red, Green, Yellow and Blue sequence of LEDS and the VIBRAMOTOR vibration. If there is
no sequence or it is incorrect, charge the system and try again; if the problem persists contact the Dainese Technical
Assistance Service or an authorized Dainese dealer.
1 1
X X
49
D - A I R ® S T R E E T S M A R T J K T