DAINESE D-AIR STREET SMART JKT.1 Notice D'utilisation page 31

TABLE 5: POSSIBLE MALFUNCTIONS
PROBLEM POSSIBLE CAUSE
THE BATTERY IS COMPLETELY RUN DOWN
WHEN THE SWITCH-ON/SWITCH-OFF
THE SYSTEM IS IN SHIPPING MODE
BUTTON IS CLOSED,
THE LED REMAINS OFF
LED CABLE OR SWITCH-ON/SWITCH-OFF
NOT CONNECTED
DURING USE, THE LED FLASHES,
ALTERNATING GREEN OR BLUE
THE BATTERY IS DRAINING FAST
WITH RED. THE SYSTEM VIBRATES
WHEN THE RED LED FLASHES
THE SWITCH-ON/SWITCH-OFF BUTTON
DURING USE, THE LED TURNS RED
IS OPEN OR THE UNIT HAS RECORDED
AND FLASHES AND THE VIBRAMOTOR
A MALFUNCTION
VIBRATES SIMULTANEOUSLY
60 I N F O R M A T I V E N O T E F O R I N F L A T A B L E
POSSIBLE SOLUTION
CHARGE THE SYSTEM FOR
AT LEAST 1,5 HOURS
CHARGE THE SYSTEM OR PRESS
THE RECOVERY BUTTON
CHECK THAT THE CABLES OF THE D-AIR
STREET SMART JKT MODULE HAVE BEEN
CONNECTED TO THE CONNECTORS
PRESENT ON THE GARMENT
CHARGE THE SYSTEM. TRY SWITCHING
THE SYSTEM OFF AND BACK ON AGAIN.
IF THE PROBLEM PERSISTS CONNECT
THE SYSTEM TO THE SOFTWARE VIA
USB AND RUN THE DIAGNOSTICS, THEN
CONTACT THE DAINESE ASSISTANCE
SERVICE INDICATING THE ERROR CODES
TRY SWITCHING THE SYSTEM OFF AND
BACK ON AGAIN. IF THE PROBLEM
PERSISTS CONNECT THE SYSTEM TO
THE SOFTWARE VIA USB AND RUN
THE DIAGNOSTICS, THEN CONTACT
THE DAINESE ASSISTANCE SERVICE
INDICATING THE ERROR CODES
P R O T E C T O R S
PROBLEM POSSIBLE CAUSE
THE SYSTEM COULD BE SWITCHED OFF;
DURING USE THE LED SWITCHES OFF
THE MAGNETIC BUTTON MIGHT NOT BE
CLOSED CORRECTLY.
DURING USE, THE LED SUDDENLY
STARTS FLASHING RED AND
THIS OCCURS WHEN THE SWITCH-ON/
THE VIBRAMOTOR VIBRATES
SWITCH-OFF BUTTON IS OPENED
SIMULTANEOUSLY AND FREQUENTLY,
BEFORE RETURNING TO CORRECT
FUNCTIONING
THE LED IS FLASHING STEADY
YELLOW WITH A FREQUENCY OF 5HZ THE SYSTEM HAS NOT BEEN REGISTERED
(5 TIMES PER SECOND)
THE LED IS STEADY YELLOW
THE SYSTEM HAS NEVER BEEN
FLASHING WITH A FREQUENCY OF 1HZ
COMPLETELY CHARGED
(1 TIME PER SECOND)
THE SYSTEM HAS NOT BEEN
THE LED IS STEADY RED
PROGRAMMED CORRECTLY
POSSIBLE SOLUTION
TRY SWITCHING THE SYSTEM OFF AND
BACK ON AGAIN. IF THE SYSTEM DOES
NOT SWITCH ON CHARGE THE SYSTEM
AND TRY AGAIN
CHECK THAT THE SWITCH-ON/SWITCH-
OFF BUTTON IS CLOSED CORRECTLY. IF
PROBLEM PERSISTS, THE CABLES MAY
TEMPORARILY BE DAMAGED. CONTACT THE DAINESE
TECHNICAL ASSISTANCE SERVICE
CONNECT THE SYSTEM TO A PC AND
FOLLOW THE REGISTRATION PROCEDURE
OF THE DEVICE
CHARGE COMPLETELY WAITING UNTIL
THE LED TURNS STEADY GREEN
CONNECT THE SYSTEM TO A PC AND
FOLLOW THE REGISTRATION PROCEDURE
TO UPDATE THE SYSTEM FIRMWARE
D - A I R ® S T R E E T S M A R T
61
J K T