DAINESE D-AIR STREET SMART JKT.1 Notice D'utilisation page 15

5
CLOSE THE TOP POSITION THE BAG MAKING SURE
AND BOTTOM OF THAT NO PARTS OF THE BAG ARE
THE POCKET FLAP FOLDED OVER, THAT IT IS NOT ROLLED
AROUND ITSELF AND THAT IT IS LYING
FLAT. USE THE SPECIFIC STRAPS TO
ATTACH THE TOP AND THE BOTTOM
OF THE BAG
28 I N F O R M A T I V E N O T E F O R I N F L A T A B L E
6 7
HOLD THE FABRIC PARTS FIRMLY CONNECT THE CONNECTORS.
AND INSERT THE FRONT PART
CONNECT THE INDIVIDUAL
OF THE AIRBAG BY SLIPPING THE
CONNECTORS OF THE
TWO ARMS INTO THE SPECIAL
GENERATOR FIRST, THEN
POCKETS AND ATTACHING THEM
THE OTHER
WITH THE STRAPS FOR THIS
PURPOSE
P R O T E C T O R S
Proceed as follows to remove the D-AIR STREET SMART JKT:
• Turn the garment with the back facing you and fold
the lower part.
• Remove the system following the installation process
from points 8 to 3 in reverse order. Remember
to disconnect the parts described above (airbag,
connectors, electronics case and generator holder).
8
WARNING!
Connection of the cables as indicated above is essential to
enable switching on and correct operation of the System.
If the bag is not lying flat, this could be dangerous in the
event of triggering.
Should you encounter difficulties or require additional
information on how to install or remove the D-AIR STREET
SMART JKT, contact your nearest DAINESE Technical
Assistance Service.
D - A I R ® S T R E E T S M A R T J K T
29