Johnson & Johnson Codman IsoCool Mode D'emploi page 4

The I
Handle is designed for use with bipolar
electrosurgical generators, such as the CMC-V
generator, or the CMC-III generator, or the
generator, for cauterizing, coagulating,
grasping, and manipulating tissue.
The handle accommodates an assortment
of I
available in a variety of lengths and diameters.
Use only I
handle. Please consult your Codman Sales
Representative for ordering information.
Electrical Insulation
The I
electrical insulation: a PARYLENE™ (clear)
coating applied over a urethane (blue) coating.
Please be aware that the clear PARYLENE
coating might begin to peel over time through
normal usage, cleaning, and sterilization
cycles. The peeling or flaking appearance
of the coating does not constitute product
failure. This potential condition is cosmetic
in nature and does not compromise product
performance or the safety of the user or
the patient.
As required by the standards of the
International Electrotechnical Commission
(IEC), the handle has been validated through
simulated use testing and was demonstrated
to be safe through 20 cleaning and
sterilization cycles.
Instructions for Use
CAUTION: Make sure the generator is
turned off (or is in standby mode) before
connecting the forceps handle or changing
the tips. User injury could result if power is
applied to the forceps during assembly.
1. In accordance with the instructions for
2. Connect the handle to the bipolar cord
199506-001-H.indd 4
C Insulated Bipolar Forceps
so ool
C Bipolar Forceps Tips, which are
so ool
C
so ool
C handle receives two coatings for
so ool
use packaged with the I
Forceps Tips, assemble a pair of tips to
the handle.
and to the bipolar generator in the
usual manner.
tips with the I
so
C
so
4
C
ool
Bipolar
ool
8/17/2012 1:22:33 PM