GE Zoneline AZ95E Mode D'emploi page 22

Installing the Zoneline
10. Make electrical connections to unit
ELECTRICAL CONNECTIONS - DIRECT CONNECT
WARNING
disconnect on front of the chassis.
death.
208/230/265 Volt Electrical Supply
A power supply kit must be used to supply power to
by the voltage, the means of electrical connection and
the amperage of the branch circuit. See the POWER
CONNECTION CHART to select the appropriate kit.
FOR 265 VOLT DIRECT CONNECT
APPLICATIONS ONLY
MPORTANT:
branch circuit MUST be done by direct connection in
not permitted by code.
GE Appliances power supply kit for the branch circuit
amperage and the electrical resistance heater wattage
desired. See the POWER CONNECTION CHART to
select the appropriate kit.
connection of components is done in accordance with
electrical codes.
Direct connection to branch circuit wiring inside the
22
APPLICATIONS
Electric Shock Hazard
EXTERNAL DISCONNECT
supply located within line of sight of the closet door
means shall be readily accessible while the air
shall not obscure the rating plate or be located on the
access panel or closet door. A properly rated switch is
a common means for electrical disconnection.
1. Remove Junction Box Cover
three screws.
2. Attach Conduit
Use the round knockout hole at the top of the
the conduit clamp and bring wire leads into the
the conduit.
49-5000561 Rev. 1