Electrical Requirements - GE Zoneline AZ95E Mode D'emploi

Installation Preparation
Questions? Call 844-GE4-PTAC (or 844-434-7822 ) or
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the owner.
Note to Owner –
•
future reference.
• Proper installation is the responsibility of the
shall not be accessible to the general public.
• Product failure due to improper installation is not
covered under the Warranty.
•
•
installation procedures as described in these
instructions when installing this air conditioner.
IMPORTANT ELECTRICAL
SAFETY—READ
CAREFULLY
WARNING
RISK OF ELECTRIC SHOCK.
installed by a qualified electrician.
local codes and ordinances.
must be properly grounded.
the nameplate of each unit.
• Aluminum building wiring may present special
problems—consult a qualified electrician.
• When the unit is not running there is still voltage to
the electrical controls.
• Disconnect the power to the unit before servicing by:
circuit breakers off at the panel.
2. Disconnect the power cord from the unit.
49-5000561 Rev. 1
Save these
Observe all governing
Be sure to leave these
Visit our Website at:
ELECTRICAL
REQUIREMENTS
Wire Size Use ONLY wire size recommended
for single outlet branch circuit
Fuse/Circuit
Breaker
on units rating plate. Proper over
current protection to the units is the
responsibility of the owner.
Grounding
circuit to unit, or through separate
ground wire provided on permanently
connected units. Be sure that branch
circuit is grounded.
Wire Sizing Use recommended wire size given
in tables and install a single branch
circuit. All wiring must comply with
local and national codes.
NOTE: Use copper conductors
only.
NOTE: All field wiring must comply with NEC and
local codes. It is the responsibility of the installer
to ensure that the electrical codes are met.
outlet branch circuit.
• Proper current protection is the responsibility
of the owner.
Recommended Branch Circuit Wire Sizes*
Nameplate
Maximum Circuit
Breaker Size
AWG - American Wire Gauge
** Based on copper wire, single insulated conductor
C
NOTE: Use copper conductors only.
WARNING
RISK OF ELECTRIC SHOCK.
properly grounded.
GEAppliances.com
AWG Wire Size**