Throttle Cable Adjustment - Swm Rs 300 R 2019 Manuel - Utilisation - Entretien

THROTTLE CABLE ADJUSTMENT

To check the correct adjustment of the throttle op-
erate as follows:
- move the upper rubber cap (1);
- by moving cable (2) back and forth check for 2
mm. clearance;
- should this not be the case, release the check nut
(3) and appropriately turn the adjustment screw
(4) (unscrewing reduces the clearance, tightening
increases it);
- Lock the check nut (3).
WARNING*: Operation with damaged throttle
cable could result in an unsafe riding condi-
tion.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine in
a closed area or in a confined area.
4
2
3
1
EN - 26
Note*: If replacing the throttle control cables (2) and
(5), operate as follows:
- Undo the screw (6) and remove the cap (7).
- Replace the cables (2) and (5); when refitting,
respect the dimension A (10mm) shown in the
photo. Then refit the protection cap (7) using the
screw (6) and adjust the cables on the handlebar
as described above.
To replace throttle control cables, first remove tha
fuel tank.
A
5
ADJUSTING THE IDLE
Adjust the carburettor with warm engine and with
the throttle control in closed position. Proceed as
follows:
- turn the idle speed adjustment screw (1) on the
throttle body, located on the right-hand side of
the vehicle, until the idle speed of 1650 RPM is
reached (turn clockwise to increase the speed
and anticlockwise to reduce the speed).
6
7
A
1