Saddle Removal - Swm Rs 300 R 2019 Manuel - Utilisation - Entretien

CAUTION*: A spark plug with too hot a heat
range may lead to preignition and possible
engine damage. A spark plug with too cold a
heat range may foul as the result of too much
carbon buildup.
Before refitting the plug, thoroughly clean the
electrodes and the insulator using a metal
brush. Smear some graphite grease on spark
plug thread, do it fully home finger tight then
tighten it to 7.37÷8.85 ft-lb. torque. Loosen the
spark plug then tighten it again to 7.37÷8.85
ft-lb.
Spark plugs which have cracked insulators or
corroded electrodes should be replaced.
EN - 28

SADDLE REMOVAL

To access to some components it is necessary to
remove the saddle by working as follows:
- Turn the fixing pin (1) anticlockwise in order to
release the saddle (2) from the locking position.
- Lift the saddle from the rear part (3) and release
it from the locking positions by pulling it towards
the motorcycle rear part (4).
2
3
4
RIGHT LATERAL PANEL REMOVAL
For its removal work as follows:
- Remove the saddle as indicated in the related
paragraph.
- Unscrew the screws (2) and remove the panel (1).
1
2
2
1