Measuring Process - Bosch Professional GLM 50-22 G Notice Originale

Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or variations in
u
temperature. For example, do not leave it in a car for extended periods of time. In case
of large variations in temperature, allow the measuring tool to adjust to the ambient
temperature before putting it into operation. The precision of the measuring tool may
be compromised if exposed to extreme temperatures or variations in temperature.
Avoid substantial knocks to the measuring tool and avoid dropping it. After strong
u
external influences on the measuring tool, you should always carry out an accuracy
check (see "Accuracy Check", page 30) before further work.
Switching On and Off
Press the button to switch the measuring tool and the laser on.
You can also switch on the measuring tool without the laser by pressing the
Press and hold the
The measured values and device settings in the memory are retained.

Measuring Process

When switching on for the first time, the measuring tool will be in the length measurement
function. When switching on every subsequent time, the measuring tool will be in the
measuring function that was last used.
Three settings are available for the reference level of the measurement. (see "Selecting
the Reference Level", page 28)
Apply the measuring tool to the point at which you want to start the measurement (e.g.
wall).
If you have switched on the measuring tool with the
the button to switch on the laser.
Press the button to start the measurement.
Once the measurement process is complete, the laser beam will switch off. For a further
measurement, repeat this process.
Measured values or end results can be added or subtracted.
For more information, you can access the online operating instructions at
www.bosch-pt.com/manuals
Bosch Power Tools
button to switch off the measuring tool.
English | 27
button.
button, then briefly press
1 609 92A 4ZL | (04.08.2021)