Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not leave the switched on measuring tool unattended
and switch the tool off after use. Other persons could be
blinded by the laser beam.
Switching On and Off
To switch on the measuring tool and the laser, press the
measuring button 2 or the Clear/ On/Off button 5.
To switch off the measuring tool, press and hold the Clear/
On/Off button 5.
For Real Time Measurement mode: the laser will automatically
turn off after 5 minutes. The measuring tool will turn off 5
minutes after laser cut off.
For all other measurement modes: the laser will automatically
turn off after 20 seconds. The measuring tool will turn off after
5 minutes (including laser cut off time).
Measuring Procedure (See Figure A)
Once switched on, the measuring tool is in the real time
measurement function. Laser is automatically activated and
tool is measuring. You can set other measuring functions by
4
repeatedly pressing button
(see "Measuring Functions").
The rear edge of the measuring tool is always the reference
point for the measurement.
Place the measuring tool against the desired starting point of
the measurement (e.g. a wall).
Note:
The measured value typically appears within 0.5
seconds and no later than 4 seconds. The duration of
the measurement depends on the distance, the lighting
conditions and the reflective properties of the target surface.
Upon completion of the measurement the laser beam is
automatically switched off.
Measuring Functions
Real Time Measurement
For real time measurements, the measuring tool can be moved
relative to the target, whereby the measuring value is updated
approx. every 0.5 seconds. In this manner for example, the
distance displayed on the screen will change in real time as
you move further or closer to the measured target.
13
2610047629.indd 13
6/6/17 9:40 AM
Publicité
Table des Matières
