Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adding/subtracting measured values in real time and length
measurement modes (see figure B)
Press button 4 to exit addition/subtraction.
In Area and Volume Measurement Modes, calculate first area/
volume measurement and then press button 3 or 6. Calculate
the second area/volume measurement and press button 3 or
6 again to get the sum.
Changing the Unit of Measure
Press and hold the function button 4 until one of the images
shown below is displayed. Use button 3 and button 6 to cycle
through the units of measurement. Once the desired unit of
measurement is displayed, press the measurement button 2 to
return to measuring.
2610047629.indd 17
To measure, press the measuring button 2.
The measured value will be shown at the
bottom of the display.
Press button 6 to add measured values or press
button 3 to subtract measured values. "+" or "–"
will appear in the middle of the display. Take
another measurement. The current measured
value will be shown at the bottom of the display,
and the previous measured value will be shown
above it.
Press button 6 to add measured values or press
button 3 to subtract measured values. The
result will be shown at the bottom of the display
after "=" , and the current measured value will be
shown above it.
17
6/6/17 9:40 AM
Publicité
Table des Matières
