Troubleshooting - Gardol GAM-E 33/1Li Instructions D'origine

10. Troubleshooting

Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period
Anl_GAM_E_33_Li_1_SPK7.indb 26 Anl_GAM_E_33_Li_1_SPK7.indb 26
GB
Possible causes
a) Motor or capacitor defective
b) Motor terminals or capacitor
disconnected
c) The mower is standing in high
grass
d) The mower housing is clogged
e) Safety switch is not inserted
f) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
- 26 -
Remedies
a) By customer service workshop
b) By customer service workshop
c) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
d) Clean the housing so that the blade
moves freely
e) Insert safety switch (see 6.)
f) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
30.10.2017 09:44:21 30.10.2017 09:44:21