Ego Power+ PH1400 Guide D'utilisation page 16

MOUNTING AND ADJUSTING THE
FRONT-ASSIST HANDLE
WARNING:
battery pack from the product when you
are assembling parts, making adjustments,
cleaning, or when the product is not in use.
1. Stop the motor and remove the
battery pack, if installed.
2. Loosen the four screws in the front-
assist handle with the supplied hex
wrench and remove the screws and
lower clamp from the front-assist
handle (Fig. 3).
3. Attach the front-assist handle and
lower clamp on the power-head
shaft and secure them by pre-
tightening the four screws. Turn the
front-assist handle upwards so that
it points toward the top of the rear handle (Fig. 4).
4. Adjust the front-assist handle position between the rear handle housing and the
coupler on the power-head shaft (Fig. 4).
5. Tighten the four screws so that the handle cannot be rotated on the shaft.
WARNING:
16
56-VOLT LITHIUM-ION POWER HEAD—PH1400
Always remove the
Never operate the tool without the front-assist handle firmly in place.
3
Screws
Lower Clamp
4
Coupler
Power-head Shaft
Front-Assist Handle
Rear Handle
Housing