Troubleshooting - Ego Power+ PH1400 Guide D'utilisation

TROUBLESHOOTING

PROBLEM CAUSE
◾
Hedge trimmer
doesn't work.
◾
◾
◾
◾
◾
◾
◾
Excessive
◾
vibration or
noise.
◾
◾
The battery pack is not
attached to the power head.
No electrical contact between
the trimmer and battery.
The battery pack is depleted.
The lock-off button is not
pressed before pressing the
trigger switch.
The battery pack or power
head is too hot.
The blade is jammed.
The hedge trimmer is not well
connected with the power
head.
Dry or corroded blades.
Blades or blade support is bent.
Bent or damaged teeth.
Loose blade bolts.
HEDGE TRIMMER ATTACHMENT—HTA2000
SOLUTION
◾
Attach the battery pack to the power
head.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold
it, then press the trigger to turn on the
hedge trimmer.
◾
Allow the battery pack or power head
to cool until the temperature drops
below 152°F (67°C).
◾
Remove the battery pack from the tool.
Remove the obstruction carefully and
then reinsert the battery and restart
the tool.
◾
Disconnect the hedge trimmer from the
power head. Reconnect them following
the section" CONNECTING THE HEDGE
TRIMMER ATTACHMENT TO THE
POWER HEAD" in this manual.
◾
Lubricate the blades.
◾
Replace with a new blade or support
following the section" REPLACING THE
BLADE" in this manual or contact EGO
service center for replacement.
◾
Replace with a new blade following
the section" REPLACING THE BLADE"
in this manual or contact EGO service
center for replacement.
◾
Tighten the blade bolts. Using a 3mm
hex wrench (not included), turn the bolt
clockwise to tighten.
29