Konica AUTOREFLEX T3 Mode D'emploi page 19

Table des Matières

Publicité

4. While lightly pressing down the cartridge, turn the Film
Wind Lever (14) and take up the film on the spool.
Ascertain that the teeth of the Sprocket (35) are in gear
with film perforations before the back cover is closed.
Depress the back cover with a finger tip, and it will be
closed with ease.
4. Halten Sie die Patrone weiterhin fest und betätigen Sie
den Filmaufzugshebel (14). Transportieren Sie den Film
soweit, bis die Perforation oben und unten von den
Zähnen der Filmtransportrolle (35) erfasst wird. Schlies-
sen Sie die Camerarückwand, sie wird durch leichten
Druck verriegelt.
4. Tour en appuyant légèrement sur la cartouche, action-
ner le levier d'armement (14) et entraîner le film.
Appuyer sur le dos avec un doigt et il se verrouille
automatiquement.
4. Håll fortfarande fast kasetten och låt filmen rulla upp
sig på den högra spolen genom att vrida film uppvrid-
ningsarmen (14). Förvissa Er om att frammatarhjulets
taggar (35) griper in i filmens perforering. Därefter kan
kameralockets stängas med ett lätt tryck.
5. Flip up the Film Rewind Crank (22) and turn it in the
direction indicated by an arrow mark on it to reduce the
slack of the film.
5. Klappen Sie die Filmrückspulkurbel (22) nach aussen
und drehen Sie die Kurbel vorsichtig in Pfeilrichtung, bis
Sie einen leichten Widerstand spüren, der Film ist jetzt
in der Patrone gestrafft.
5. Après avoid fermé le dos, relever la manivelle de
rebobinage (22), et la tourner dans le sens indiqué par la
flèche pour bien tendre le film.
5. Fäll ut återspolningsveven (22) och vrid den försiktigt i
den riktning som pilen anger tills Ni känner ett lätt
motstånd. Filmen är då sträckt.

Publicité

Table des Matières
loading

Produits Connexes pour Konica AUTOREFLEX T3

Table des Matières