Konica AUTOREFLEX T3 Mode D'emploi page 18

Table des Matières

Publicité

1. Pull the Back Cover Lock (28) and open the Back Cover
(39).
2. Put a film cartridge into the Film Chamber (30) as
through it slid into the chamber at a slant from above the
underside.
1. Ziehen Sie die Verriegelung (28) nach unten und öffnen
Sie die Camerarückwand (39).
2. Schieben Sie die Filmpatrone in die Filmkammer (30).
1. Tirer sue le verrou du dos (28) et ouvrir ce dernier (39).
2. Diriger la cartouche vers le fond de l'appareil en orientant
le côté d'où soit l'axe vers le bas de l'appareil. Placer
ensuite la cartouche dans le logement (30).
1. Dra i bakre lock (28) i riktning mot Er och öppna locket
på kamerans baklocket (39).
2. Sätt kasetten för filmhylsan (30). För in den snett
underifrån.
1 8
3. Pull out the film while the cartridge is lightly pressed
down and then choose any slit of the Film Take-up Spool
(36) into which the film tip may be inserted with ease and
insert the film into the slit.
3. Halten Sie die Patrone fest und ziehen Sie den Filmanfang
soweit heraus, bis er in einen beliebigen Schlitz (37) der
Aufwickelspule (36) gesteckt werden kann.
3. Insérer l'extrêmité de la pellicule dans une fente de la
bobine d'entraînement (36). On peut utiliser toutes les
fentes. Choisir ainsi celle qui se présente le mieux.
3. Håll fast kasetten och dra ut filmen så långt att den kan
fästas i springan på den motsatta spolen (36).

Publicité

Table des Matières
loading

Produits Connexes pour Konica AUTOREFLEX T3

Table des Matières