Cleaning; Troubleshooting - SilverCrest SMS 50 A1 Instructions D'utilisation Et Consignes De Sécurité

Cleaning

• Switch the product off, remove all plugs before
cleaning!
• No acid, chafing or solvent cleaning agents
should be used or the product can be
damaged.
• Only clean the outside of the product using a
soft, dry cloth!
• For persistent soiling, a mild cleaning agent
can be used.
• It is necessary to repair the product if they have
been damaged in any way, for example, if the
housing is damaged, if liquid or objects have
penetrated the device or if the product has
been exposed to rain or moisture.
• Repair work is also required if the device is
not working properly or has been dropped.
If smoke is produced, or there are any
unusual sounds or smells, turn the product off
immediately. In such cases, the product should
not be used until it has been inspected by
authorised service personnel. Only have the
device repaired by qualified personnel. Never
open the housing of the product.
• Only use a clean, dry cloth for cleaning the
product and never use any corrosive liquids.
Use a slightly moistened cloth and a mild
cleaning agent to remove stubborn dirt.

Troubleshooting

To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
• Ensure that the AC cord of the apparatus is
properly connected .
• Ensure that there is power at the AC outlet.
• Press the standby button to turn the unit on.
Remote control does not work
• Before you press any playback control button,
first select the correct source.
• Reduce the distance between the remote
control and the unit.
• Insert the batteries with their polarities (+/-)
aligned correctly.
• Replace the batteries.
• Aim the remote control directly at the sensor on
the front of the unit.
No response from the unit
• Disconnect and reconnect the AC power plug,
then turn the unit on again.
Clock setting erased
• Power has been interrupted or the power cord
has been disconnected.
• Reset the clock.
I cannot find the Bluetooth name of this
unit on my Bluetooth device
• Ensure the Bluetooth function is activated on
your Bluetooth device.
• Re-pair the unit with your Bluetooth device.
The disc does not play
• There is no disc inside the unit ("NO CD"
appears on the display).
• Insert the disc correctly with the label side
facing up.
• Clean the disc.
• PAUSE mode may be activated, deactivate it.
• A non-valid disc has been inserted.
• Condensation may have formed inside the unit
due to a sudden change in temperature. Wait
about an hour for it to clear and try again.
This is a 15 mins power off function, one
of the ERPII standard requirement for
saving power
• When the unit's external input signal level is
too low, the unit will turn off automatically in
15 minutes. Please increase the volume level of
your external device.
GB/IE 43