Select The Equaliser; Adjust The Brightness; Set The Clock; Time Display - SilverCrest SMS 50 A1 Instructions D'utilisation Et Consignes De Sécurité

Select the equaliser

Press the EQ button repeatedly on the main
unit or on the remote control to select: [POP] -
[CLASSIC] - [ROCK] - [JAZZ] - [FLAT].

Adjust the brightness

Press the DIMMER button on the remote control
to select brightness level.

Set the clock

Manual Setting the clock can only be done in
STANDBY mode.
1. In STANDBY mode, press and hold the
CLOCK button on the remote control until the
hour digits are flashing.
2. Press the , buttons on the remote control
to adjust the hour digits while flashing, then
press ENTER or CLOCK button on the remote
control to confirm, then the minute digits will
flash.
3. Press the , buttons on the remote control
to adjust the minute digits while flashing, then
press the ENTER or CLOCK button on the
remote control to confirm.
• Each activated state will be cleared if any
buttons are not pressed within 20 seconds.
• During Time Setup press the
unit or the button on the remote control to
select 12/24 hour format.
• If the system is unplugged or if a power failure
occurs, all setups of the unit will be erased.

Time Display

Press the CLOCK button to show the current time
on the display for a few seconds.
38 GB/IE

Set the alarm timer

The clock must be correctly set for the timer to
operate correctly.
1. In STANDBY mode, press and hold the
2. Press the
3. Press the
4. Press the
5. Press the
6. The display will show the "TMR ON" or
button on the
Note:
The operating time to set each step must not take
longer than 20 seconds or it will return to time
display.
Activate and Deactivate the Alarm Timer
Press the TIMER button on the remote control to
activate and deactivate the alarm timer.
Stop Alarm Ring
When the alarm rings, press the
remote control. The alarm stops but the alarm
settings remain.
TIMER button on the remote control until the
hour digits flash on the display.
, buttons on the remote
control to adjust the hour digits, and then press
the ENTER or TIMER button on the remote
control to confirm, the minute digits will flash
on the display.
, buttons on the remote
control to adjust the minute digits, and then
press the ENTER or TIMER button on the
remote control to confirm, the tuner timer will
flash on the display.
, buttons on the remote
control to select FM / CD / USB mode, and
then press the ENTER or TIMER button on
the remote control to confirm, the display will
show the volume level.
, buttons on the remote
control to adjust the volume, and then press
the ENTER or TIMER button on the remote
control to confirm.
"TMR OFF" flashing on the display. Press the
, buttons on the remote control to select
TMR ON to enable the timer, otherwise
select TMR OFF to disable the timer. Press
the ENTER or TIMER button on the remote
control to confirm.
button on the