Fm Operation; Presetting Stations Manually; For Better Reception; Showing Rbds Information - SilverCrest SMS 50 A1 Instructions D'utilisation Et Consignes De Sécurité

1. Pair your device with the unit.
2. Play music via your device (if it supports
A2DP).
3. Use supplied remote control to control play (if it
supports AVRCP).
• Press the button on the unit or the
on the remote control to pause the playback.
• To resume playback, press the
the unit or the button on the remote control
again.
• To skip to a track, press the
on the remote control.

FM operation

Auto scan and save preset stations
Fully unwind the FM aerial. Extend the aerial
and place it in the position that offers the best
reception.
1. Press the SOURCE button on the main unit or
press the TUNER button on the remote control
to select FM mode.
2. Press and hold the PROG button on
the remote control to activate automatic
programming. All available stations are
programmed in the order of waveband
reception strength.
The first programmed radio station is played
automatically.
Tune to a preset radio station
Press the ALBUM/PRESET/
the remote control to select a preset number that
you want.
Tuning in a station
• Press and hold the
remote control, the frequency changes down or
up automatically until a station is found.
• Press the / buttons repeatedly on the
remote control until you find the station you
want.
42 GB/IE
button
button on
/ buttons
, buttons on
/ buttons on the
If reception is still poor, try to adjust the position
of the aerial or try to move the radio to another
location.

Presetting stations manually

You can preset up to 20 FM stations.
1. Tune in the desired station, then press the
PROG button.
2. Press the ALBUM/PRESET/
on the remote control to select the preset
number then press the PROG button to
confirm.
3. Repeat above steps 1 to 2 for each station
you want to store in memory with a preset
number.

For better reception

• Fully unwind the FM aerial. Extend the FM
aerial and place it in the position that offers the
best sound reception.
• Press the ST/MONO button on the remote
control to switch between stereo and mono
mode. This is helpful when receiving poor
signal reception.

Showing RBDS information

If you tune to a RBDS station, press the INFO
button repeatedly on the remote control to scroll
through the following information: Station Text /
Station Name / Program Type / Rds Clock

Storage when not in use

Store the product in a dry location to protect it
from dust and direct sunlight.
, buttons