Dometic FRESHJET FJ 1700 Instructions De Montage page 13

FreshJet
8.5 Installing the roof air conditioner with Chillout ADB
A
NOTICE! Damage hazard
Observe the structural strength of the roof of the vehicle. The roof of the
vehicle must be able to bear the weight of the roof air conditioner. The
roof must not be indented or deformed by the weight of the unit, even
over a longer period of time.
See fig. 0
➤ Lift the roof air conditioner onto the roof of the vehicle.
➤ Position the roof air conditioner over the installation opening.
Observe the direction of travel.
Attaching the roof air conditioner
See fig. a
➤ Position the roof air conditioner into the mounting opening using the conical
noses.
See fig. b
➤ Choose the suitable seal in accordance with the following table:
Roof thickness
25 – 30 mm
30 – 40 mm
40 – 60 mm
➤ Position the seal with the adhesive side on the ADB.
➤ Fasten the mounting frame (3) on the underside of the roof air conditioner with
the 4 screws supplied.
See fig. c
A
NOTICE! Damage hazard
Tighten to the specified torque.
➤ Tighten the screws using a torque spanner and a fastening torque of 2.5 Nm.
EN
Seal thickness
15 mm
30 mm
45 mm
Installation
13