Using The Timer - Atag OX30 11C Mode D'emploi

how to use your oven
delaying the cooking
how to use your oven

using the timer

GB 56
Carry out the same procedure as for programmed cooking. After setting the
cooking time.
Press the "end of cooking"
cooking is indicated and flashes, as does the
indicate that it may be adjusted.
example : It is 12.30.
You have programmed a cooking time of 30 min.
The end of cooking time indicated is 1 pm (13.00).
Adjust the end of cooking time using the
example : End of cooking time: 2 pm (14.00).
Once the end of cooking time has been programmed, the end of cooking
symbol stops flashing.
The oven will now start heating up in time for cooking to be finished by 2
pm (14.00).
When cooking finishes the oven gives a series of beeps for a few minutes.
To switch the beeps off, press the START/STOP touch control for one sec-
ond.
NOTE: You may consult or change the end of cooking time at any time by
.
pressing the
To cancel your program, press the START/STOP touch control.
Your oven is fitted with an electronic timer for your use other than in
conjunction with the oven.
ATTENTION: This program is separate from the oven. It cannot be used
to stop automatic cooking. This program may never-theless
be used even when the oven is in use. In this case, the timer display
takes priority over the clock display.
Press the timer touch
bol appears and flashes.
+
Press the or
required (up to 59 minutes and 59 seconds).
The display stops flashing after a few seconds and the timer starts, counting
down the time in seconds. When the time is up, the timer bleeps to warn you
and the symbol flashes.
Stop the bleeping by pressing the
Normal time is now displayed.
NOTE: You may change the remaining time at any point by pressing the
touch control and using the
cancel the timer program, set the time at
, touch control; the time for the end of
+
.
The display flashes and the timer sym-
-
touch controls to obtain the length of time
touch control or START/STOP.
+
-
or
touch controls. To
0.00
symbol to
-
or touch controls.
and press START/STOP .