C.fn: Setting Custom Functions; Protection Functions - Hahnel MODUS 600RT Mode D'emploi

C.Fn: Setting Custom Functions

The following table lists the available and unavailable
custom functions of this flash.
APS
Zoom
135
1. Software Version
Press <Zm/C.Fn> Backlight/Custom Setting Button for
2 seconds or longer until C.Fn menu is displayed. The
"Ver x.x" in the topright corner refers to the software
version.
2. Select the Custom Function No
• Turn the Select Dial to select the Custom Function
number
3. Change the Setting
• Press <SET> button and the Setting No. blinks.
• Turn the Select Dial to set the desired option. Pressing
<SET> button will confirm the settings.
• After you set the Custom Function and press function
button 4, the camera will be ready to shoot.
4. C.Fn Default
In the C.Fn menu, a long press of the "Clear" button for
2 seconds until "OK" is displayed on the panel, which
means the values in C.Fn are reset to their default
options
40
14mm 133mm
20mm 200mm
Modus 600RT

Protection Functions

1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash
head, do not fire more than 30 continuous flashes in
fast succession at 1/1 full power. After 30 continuous
flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then
fire more flashes in short intervals, the inner over-
temperature protection function may be activated and
make the recycling time over 10 seconds. If this occurs,
allow a rest time of about 10 minutes, and the flash unit
will then return to normal
• When the over-temperature protection is active,
< > is shown on the LCD display
Number of
Power Output level
flashes that
will activate
1/1
over-
1/2 +0.7
temperature
1/2 +0.3
protection:
1/2
1/4(+0.3,+07)
1/8(+0.3,+07)
1/16(+0.3,+07)
1/32(+0.3,+07)
1/64(+0.3,+07)
1/128(+0.3,+07)
Number of flashes that
will activate over-
temperature
protection in high-speed
sync triggering mode:
Modus 600RT
Number
of Flashes
30
40
50
60
100
200
300
500
1000
Power Output Times
1/1 15
1/2(+0.3,+07) 20
1/4(+0.3,+07) 30
1/8(+0.3,+07)
1/16(+0.3,+07) 40
1/32(+0.3,+07)
1/64(+0.3,+07) 50
1/128(+0.3,+07)
41