M/A/B/C: Wireless Flash Shooting With Different Flash Modes For Each Goup - Hahnel MODUS 600RT Mode D'emploi

M/A/B/C: Wireless flash shooting
with different flash modes for
each goup
You can shoot with different flash modes set for each firing
group (M/A/B/C). The flash modes that can be set are
TTL auto flash / manual / OFF. When the flash mode is in
TTL exposure is controlled to result in standard exposure
for the main subject as a single group. This function is
for advanced user who are very knowledgeable and
experienced in lighting.
SLAVE
A
SLAVE B
32
2. Turning ON/OFF group
M (master speedlight)
/ A / B / C
• Press Function Button
3 < >. Then turn
Gr
the Select Dial to set
the group ON/OFF
• Press Function Button
3 < > again to
Gr
select the next group.
Press <SEL> button to
confirm
3. Setting the
stroboscopic flash
parameters
• Press Function Button
4 < >. This
MENU1
will display <
MENU2
> which enables
selecting of power
< >, number
< >
flashes
Times
frequency < >
Hz
• Press < > or
> <
or
Times Hz
to adjust the relevant
setting
SLAVE
C
MASTER <M>
Modus 600RT
and
<
>
Modus 600RT
1. Set master Unit
• Press the < >
MODE
button and set the flash
mode to < > .
MASTER
See Page 26
2. Set the firing group of
the slave units
• Operate and set the
slave units one by one
• Press Function Button
< > to assign
Gr
the speedlight to group
<A>, <B> or <C>. See
3. Set the flash modes
• Set the flash mode of
each firing group by
the operation of the
master speedlight. See
Page 27
4. Set the flash output
and flash exposure
compensation amount
• While a firing group
is selected, press
Function Button 3 <
>
• Turn the Select Dial to
set the flash function
corresponding to
flash mode, and press
<SET> Button to
confirm
• When using the <M>
mode, set the flash
output power
• When using the <TTL>
mode, set the flash
exposure compensation
amount as required
• Repeat step 4 to set
the flash function of all
groups
• Press Function Button
4 to return to the
shooting-ready state
33