Using Automatic Wireless Flash With Multiple Slave Units; Wireless Flash; Multiple Master Unit; M: Wireless Flash Shooting With Manual Flash - Hahnel MODUS 600RT Mode D'emploi

Using Automatic Wireless Flash
with Multiple Slave Units
When stronger flash output or more convenient lighting
operation is needed, increase the number of slave
speedlight's. To add slave units, use the same steps as
setting "automatic wireless flash with a single slave
unit" (Page 28). Any slave speeedlight can be set as
group (A/B/C).
When the number of slave units is increased or the
master flash firing is set to ON, automatic control is
performed to fire all flashes at the correct flash output to
ensure that the total flash output results in the standard
exposure.
• If the slave units auto power off takes effect, press the
master unit's test flash button to turn on the slave unit.
Note that the test flash cannot be performed while the
camera's metering timer, etc. is operating
• The slave units auto power off setting can be changed
(C.Fn-Sv / APOT page 42)
• In the C.Fn settings you can enable a beeper to sound
when a Modus 600RT is recharged and ready to fire again
Advanced setting with fully automatic
wireless flash
With the wireless system the following functions set on
the master unit will automatically be adjusted on the slave
unit. For this reason you do not need to operate the slave
unit (s) and can operate it from the master in the same
way as normal flash photography.
• Flash Exposure Compensation <
• Manual Flash (Page 20)
• MULTI: Stroboscopic Flash (Page 21)
30
> (Page 18)
Modus 600RT Modus 600RT

Multiple Master Unit

You can use two or more cameras with master flash
units on each to change camera shooting while keeping
the same lighting setup (slave units) in wirelesss flash
photography.
M: Wireless Flash Shooting with
Manual Flash
This describes wireless using manual flash. You can shoot
with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
MULTI: Wireless shooting with
Multi repeating flash stroboscop-
1. Setting the manual
flash mode to <M>
• Press Function Button
4 < > to choose
Gr
the group
• Then press Function
Button 3 < > to
MODE
set the <M> mode
2. Setting manual flash
output power
• Press Function Button
2 < >. Turn the
Select Dial to adjust the
flash output of the group
• Press <SET> button to
confirm
3. Setting individual group
flash output power
4. Each group M (Master
speedlight) / A / B / C
can be set individually
to different power level
• Set any group to <--->
to turn the power of this
group
1. Setting <MULTI>
stroboscopic flash
• On the Master
Speedlight press
<MODE> button until
<MULTI> is displayed
• Turn the Select Dial to
adjust the flash output
power. Press <SET>
button to confirm
31