C.fn: Setting Custom Functions; Protection Functions - Hahnel MODUS360RT Manuel D'utilisation

• The <ZOOM/C.FN> button will not work.

C.Fn: Setting Custom Functions

The following table lists the available custom functions of this flash.
C.Fn Custom Functions
Custom Function
Signs
St
AF
bL
1. Press the < ZOOM > Button for 2 seconds until C.Fn menu is displayed.
2. Turn the Select Dial to select a Custom Function.
3. Press the <SET> Button and the Setting blinks.
4. Turn the Select Dial to set the desired setting. Pressing the <SET> Button
will confirm the settings.
5. Press the <ZOOM> Button to exit.

Protection Functions

1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire
more than 30 continuous flashes in fast succession at 1/1 full power.
After 30 continuous flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then fire more flashes
in short intervals, the inner over-temperature protection function may
be activated and make the recycling time over 10 seconds. If this
occurs, allow a rest time of about 10 minutes, and the flash unit will
then return to normal
• When the over-temperature protection is active, <
the LCD display
Number of flashes that will activate over temperature protection:
Function Setting No.
Auto ON
Power off OF
AF - assist 1 - 5
beam OF
Backlighting 10
control OF
ON
28
Setting & Description
Auto Power off enable
Auto Power off disable
AF Assist beam level
AF Assist beam disable
Off in 10 sec.
Always Off
Always lighting
> is shown on