Start-Up; Normal Operation - Phoenix Mecano RK ROSE+KRIEGER DuoLine S Notice D'assemblage

7.3 Start-up

Only persons who have read and understood these assembly instructions completely may
commission the linear unit.
The function of this linear unit results in forces that can lead to personal injury or property
damage.
It is imperative that you observe the safety regulations and the limits of the linear unit.
Before commissioning a linear unit RK DuoLine S 80 with an overall length
the guide carriage must be pushed as close as possible to each end element once.
The procedure guarantees the function of the spindle support inside the linear unit.

7.3.1 Normal operation

Check the linear unit when in operation regularly for correct performance of its function.
During normal operation, look out for obvious changes in the incomplete machine. Should faults
arise, the linear unit is to be shut down immediately in order to avoid damage.
Components made from steel are fitted to this linear unit. Use in environments with high
humidity or where contact with other components occurs may lead to surface corrosion. Surface
corrosion is not a reason for complaint.
The operating instructions for the complete machine in accordance with Machinery Directive
2006/42/EC are binding for the linear unit as part of a complete machine.
7. Life Phases 7. Life Phases 7. Life Phases

1172mm,
75 75 75