Phoenix Mecano RK ROSE+KRIEGER DuoLine S Notice D'assemblage page 72

7. Life Phases 7. Life Phases 7. Life Phases
Screw pins
•
Use the adapter disk centring lug in the hollow shaft of the toothed disk shaft
•
Tighten the fixing screws alternately in a diagonal sequence
•
Centre the bolt pins on the adapter disk
•
Tighten the fixing screws alternately in a diagonal sequence
DIN EN ISO 4762 8.8
Coupling installation
Coupling installation - pin versions with / without key
•
Push the coupling lug on to the pin
•
Observe the plug-in depth at the lug
•
Torque the clamping screw (DIN EN ISO 7380)
•
max. operating speed n = 3000 rpm
Coupling installation - tension ring lug
•
Push the tension ring lug on to the pin
72 72 72
DIN EN ISO 4762 12.9
Screw pins
Coupling
Coupling
Locking screw DIN EN ISO 7380